The L-6000 is a hand operated threaded insert tool for use with the following insert thread
sizes: 4-40; 6-32; 8-32; 10-24; 10-32; 12-24; 1/4-20; 1/4-24, 3MM; 4MM; 5MM; and 6MM.
(Refer to figure 1)
Pull knob (A) completely out and
place insert onto pull-up stud. Holding
insert stationary, push knob until it is all
the way into the barrel (B). The insert
should now have all threads engaged onto
the pull-up stud. Hold tool at a 90° angle to
work, and place insert into the hole
in work piece. Squeeze handle (C) toward barrel
(B) until resistance is felt. The handle will not touch the barrel. DO NOT apply excessive force
or the threads will be stripped. Release handle (C) and pull knob (A) completely out, this will
release pull-up stud from the insert.
REPLACING BROKEN OR DAMAGED PULL-UP STUDS:
(Refer to fig. 2)
1. Unscrew anvil sleeve. L-28 and remove.
2. Loosen 3 set screws, L-5 using the access
hole with hex key (include), by rotating knob to
expose set screws.
3. Loosen 2 set screws at access hole located below
L-32 on barrel, again rotate knob.
4. Unscrew pull-up stud by holding it firmly in place, a
vice may be necessary to hold the pull-up stud. Turn
entire tool counter clockwise to remove from
5. Replace pull-up stud by reversing instructions.
DO NOT DAMAGE OR SCAR THE PULL-UP STUD, THIS WILL PREVENT SMOOTH
OPERATING WHILE STUD ROTATES IN THE ADJUSTABLE ANVIL.
NOTE: If replacing pull-up stud with a different thread size, it requires changing adjustable
anvil, L-29; collar, L-15; and in some cases, the coupling, L-20.
OILING: A drop of oil at set screw openings on the barrel will keep the tool operating smoothly.
WEB "QUICK THREAD" THREADED INSERT TOOLS
|Home | Washers | Rentals & Repair | Charts | Articles | Sitemap | Contact Us
Hanson Rivet & Supply Co. Inc.
Phone: 818-485-0500 Fax: 818-485-0540 firstname.lastname@example.org
Copyright © 2014 Hanson Rivet. Site designed by Web Sights Technology